Clear-Com CB-222 - Manual (Page 22)

18 Tempest®24 00 MasterBelt
• Volume Limit - a minimum and maximum volume level can be set per MasterBelt or BeltStati on. In loud
environments a higher minimum volume may be desirable, while in quiet environments a lower maximum volume
may be preferable. Default setti ng is OFF for both Min Volume and Max Volume.
» To set a minimum volume: Press MENU, select Set Controls>Volume Limit>Min Volume and use the volume
knob to adjust to the desired level. Press ENT to save.
» To set a maximum volume: Press MENU, select Set Controls>Volume Limit>Max Volume and use the volume
knob to adjust to the desired level. Press ENT to save.
• Stage Announce - the Stage Announce functi onality is not applicable when using BeltStati ons in a MasterBelt
applicati on.
• Call Alert - a call alert can be used to send an audible or vibrati ng signal to other users’ BeltStati ons on the same
channel. A call signal is only sent when the originator’s TALK butt on is acti ve. Press MENU, select Set Controls>Call
Alert and choose either
Audible , Vibrate , Both or Disable . Default setti ng is Both .
• Call Butt on - the CALL butt on is used to trigger call alerts. Press MENU, select Set Controls>Call Butt on and Enable or
Disable the butt on. Default setti ng is Enable .
• Select Relay - the relay functi onality is not applicable when using BeltStati ons in a MasterBelt applicati on.
• Relay Butt on - the relay functi onality is not applicable when using BeltStati ons in a MasterBelt applicati on.
• Wireless ISO - this functi onality is not applicable when using BeltStati ons in a MasterBelt applicati on.
• Volume Press - the volume controls can be set to “Volume Press” which requires a “press and turn” acti on to adjust
the volume levels. This helps prevent inadvertent adjustments. Press MENU, select Set Controls>Volume Press and
Enable or Disable this feature. Default setti ng is Disable .
• Talk Tones - this is an audible tone that can be heard in the headset when the TALK butt on is pressed. Press MENU,
select Set Controls>Talk Tones and Enable or Disable this opti on. Default setti ng is Enable .
• Delay Switch - when enabled this requires the channel knobs to be pressed and held slightly longer in order to
change channels. This helps prevent inadvertent adjustments. Press MENU, select Set Controls>Delay Switch and
Enable or Disable this opti on. Default setti ng is Disable .