Clear-Com CB-222 - Manual (Page 8)

4 Tempest®24 00 MasterBelt
Tempest batt eries are not subject to transport regulati ons of dangerous goods because they fulfi ll the following regulatory
provisions:
» ADR 188
» IATA A45
» IMDG 188
Batt ery Storage
Long-term storage of batt eries at maximum charge can result in permanent loss of capacity.
For long term storage of batt eries, charge/discharge the batt eries to approximately 60% of capacity. Batt eries stored for
longer than one year should be recharged to 60% annually. Trickle charging is not recommended due to the very low self
discharge rate of the batt eries.
As with all batt eries:
• Do not burn.
• Do not expose batt eries to excessive heat such as sunshine, fi re or other heat sources.
• CAUTION – Danger of explosion if batt ery is incorrectly replaced. Replace only with the same or equivalent type.
• Properly dispose of used batt eries promptly.
• Keep away from children.
Maintenance and Care
Cleaning
Generally, the Tempest Wireless hardware should be cleaned only with a dry cloth. A soft cloth with rubbing alcohol may
be used to wipe the units if needed. Never spray solvents or chemicals onto the units.
Because of Tempest’s weather resistant design, it is not highly suscepti ble to dust or airborne contaminants. However, all
electronic devices can be suscepti ble to parti culate contaminati on. If exposed to an extremely dusty environment, contact
an authorized Tempest service center for internal cleaning.
Temperature and Humidity
Ideally, all electronics should be stored and used in a controlled environment with moderate temperature and humidity.
Tempest components are designed to be very durable, and can tolerate a wide range of environmental conditi ons.
Install the MasterBelt in a locati on where it will not be exposed to extreme weather conditi ons. Protect the unit against
dust or moisture. Always protect any AC power connecti ons from the elements with safety in mind.
The MasterBelt and BeltStati ons are designed to work wherever people work. While the design is weather resistant, the
headset XLR connector on the bott om is not waterti ght. MasterBelts or BeltStati ons should not be submerged in liquids.
Protect the batt ery compartment from water when changing batt eries. The batt ery compartment off ers a route to the
electronic circuitry.