Clear-Com Logic-Maestro - Manual (Page 37)

Clear-Com Communication Systems
Eclipse Logic Maestro Instruction Manual 1 - 2 3
Figure 1-39: Crosspoint Trigger Type Menu
The crosspoint trigger can be set to operate when either source to
destination crosspoints are made or bidirectional crosspoints are made
between any of the sources and destinations configured. Right click
on the menu item to select the crosspoint trigger type.
Crosspoint Trigger Sources
Crosspoint trigger sources can be added to the list by dragging and
dropping devices from the Direct/Interfaces, Fixed Groups and Panels
lists onto the source list whether or not it is open. If the source list is
opened then dropping a new source onto an existing source will
replace it. If there are no items already assigned to the source list
then the list name will be highlighted in red. If there are items already
assigned the list will not be highlighted but instead will be surrounded
by a green box.
Figure 1-40: Menu Selected
When the menu name is highlighted in yellow the item can be dropped
onto the menu.
Figure 1-41: New Item Added