Clear-Com HME DX121 User Manual

Page 13

Advertising
background image

9

Step 2. Connect power -

• Plug the connector at the end of the AC power supply cord into the 12-14VDC power connector

on the rear panel of the Base Station, and turn the nut on the connector clockwise to secure it to
the Base Station.

• Plug the female connector at one end of the power cord into the AC power supply, and plug the

other end into an electrical outlet.

• Press the POWER button on the front of the Base Station to turn it on. The red light above the

button should go on.

Step 3. Charge batteries -

IMPORTANT! – Before using the DX121 system, charge the batteries for the Beltpacs and/or
WH200 Headsets. Charging time for fully-discharged batteries is about 3 hours per battery.

• One battery can be charged in the battery charger at a time.
• Insert a battery in the charging port until it clicks in place.
• A red charging CHG light above the battery port stays on while a battery in the port is charging.
• A green ready RDY light above the battery port goes on when a battery in the port is fully

charged.

Battery

Red battery-

charging light

Green battery-

ready light

Base Station rear panel

Power cord

connector

AC power supply Power cord

Power supply

connector

To electrical

outlet

Advertising