Clear-Com Tempest2400 - Manual (Page 51)

45 Tempest®24 00 2 -Channel Wireless Intercom System
Adjusti ng so that each BeltStati on always appears in the same positi on of the BaseStati on display is a two step process:
1. Advance to the BaseStati on’s “Display Slot Assignment” secti on of the “Tech Menu” and select Stati c .
2. In each BeltStati on, advance to the “Base Slot” secti on of the “Tech Menu” and adjust each BeltStati on to a diff erent
slot (1 – 5). The BeltStati on designated to slot 1 will always appear on the far left of the BaseStati on display, with slot 2
appearing in the next positi on to the right, and so on.
In Stati c Mode, if a BeltStati on is not turned ON, or is logged out due to being out of range, the BaseStati on LCD will
display a very obvious “X,” making it easy to see at a glance which BeltStati ons are currently acti ve.
A Multi ple BaseStati on system that uses iSelect Roaming must choose to use “Dynamic” slots to ensure that BeltStati ons
can move from BaseStati on to BaseStati on when roaming.
Name Equipment
Name the BaseStati on with a descripti ve name which will appear on the BeltStati on LCD display. This is most helpful when
iSelect Roaming will be used to roam between BaseStati on coverage areas. The BaseStati on name can include up to 14
characters.
Name each BeltStati on with a descripti ve name. Unti l the name is changed, a hexadecimal serial number is displayed.
The fi rst six characters of the BeltStati on name will be displayed on the BaseStati on LCD display. Naming is a personal
preference opti on and is not essenti al.
Personal Preferences
To confi gure each BeltStati on, adjust any of the following to suit individual needs. None of these adjustments are required.
Note that more opti ons are available under the “Set Controls” menu and become visible by scrolling.
• “Lock Keys” to prevent inadvertent changes.
• “Menu Lock” allows you to lock individual users out of their respecti ve BeltStati on menu. Access can only be
regained by entering a 3-digit security key code initi ally set at the BaseStati on.
• Disable “Batt ery Alert” to prevent the batt ery alert tone in the headset.
• Dim the LCD and LEDs to be less conspicuous in a dark environment.
• Limit talking to push-to-talk mode by selecti ng Momentary . Latch is the default.
• Disable the ability to talk on any channel, but allow listening.
• Disable the ability to access any channel not required.
• Adjust minimum and maximum volume levels. In loud environments a higher minimum volume may be desirable,
while in quiet environments a lower maximum volume may be preferable.
• Volume controls can be set to “Volume Press” which requires a “press and turn” acti on to adjust the volume levels.
This helps prevent inadvertent adjustments.
• When Stage Announce functi onality is enabled in the BaseStati on, the STAGE butt on can be disabled for individual
BeltStati ons.
• The CALL alert can be set to Audible , Vibrate , Both or Disable . The default is Both . A call signal can be initi ated by the
CALL butt on or the TALK butt on, depending on your preference.
• When relay functi onality is enabled in the BaseStati on, select the relay to be acti vated by the BeltStati on. Then
select the BeltStati on trigger that will acti vate the relay.
• Wireless ISO can be disabled, if desired.