Quickstart guide – Clear-Com Tempest900 User Manual

Page 3

Advertising
background image

6

7

8

●

Plug a headset into each BeltStation.

●

To set Mic Gain, Press MENU and scroll down to Set Controls.

●

Scroll to Mic Gain and Press ENTER.

●

Set the Mic Gain for the headset that you are using; speak loudly into the
microphone and adjust the setting so that the blue TALK LED starts to flash
red. Press ENTER to save.

●

Select the desired communication channel by pressing the A or B channel
selector.

●

Adjust the headset listening volume by turning the A or B rotary control.

●

Press the TALK button to talk to others on the selected channel (the blue
flashing LED will remain lit when talk is enabled on that channel)*

●

Confirm the desired talk channel and talk status by observing the BeltStation
LCD screen.

●

Select the correct intercom type on the front of the BaseStation

» Intercom type select switch A&B controls both intercom channels A and

B.

» CLEAR-COM is used for Clear-Com and Clear-Com compatible 2-Wire

systems.

» RTS is used for RTS and RTS compatible systems.
» BAL is used for Telex AudioCom & AudioCom compatible systems.

●

Connect 3-PIN XLR cables to the back of the BaseStation for the appropriate
channel.

●

Press the left SEL button to select an intercom channel (A or B); press the
right SEL button to select 2-Wire operation.

●

Use the IN and OUT rotary controls to set the IN (from 2-Wire to BaseStation
and OUT (from BaseStation to 2-Wire) levels.

●

Perform Auto Null from the BaseStation*

●

Connect RJ-45 cables to the back of the BaseStation for the appropriate
channel.

Note: The intercom type select switches do not apply to 4-Wire

operation.*

●

Press the left SEL button to select an intercom channel (A or B).

●

Press the right SEL button to select 4-Wire operation.

●

Use the IN and OUT rotary controls to set the IN (from 4-Wire to BaseStation
and OUT (from BaseStation to 4-Wire) levels.

*Refer to the Tempest Owner’s Manual for detailed system information.

Pair BeltStations to the BaseStations

Start Communicating

Connecting to External 2-wire

Intercom Systems

Connecting to External 4-wire

Intercom Systems

5

●

Confirm the BaseStation is powered ON.

●

Confirm the BeltStation is powered OFF.

●

Connect the 3.5mm data pairing cable from the BaseStation to the BeltStation.

●

Power ON the BeltStation while observing the BeltStation LCD screen; the
BeltStation will vibrate and “Pairing Complete” will appear momentarily on the LCD
screen if pairing was successfull.

●

The BeltStation will return to the operational screen and log into the BaseStation.

●

The BeltStation will appear in the first available slot on the LCD screen.

●

Repeat for each BeltStation.

Note: BeltStations are named to their default

setting name. They can be renamed.

QuickStart Guide

Useful tips

9

9

TALK buttons can be set to three different modes: Latch, Momentary,
or Disable.

9

9

Mic gain, sidetone, and volume levels can all be set based on each
user’s needs.

9

9

Set a single BaseStation to Split or Shared mode and use an
unlimited number of BeltStations that operate in a push-to-talk/listen
only mode.

9

9

When syncing multiple BaseStations it is important to power ON
one BaseStation at a time, starting with the first BaseStation in the
sequence.

9

9

For more information on these features and other advanced settings
please refer to the Tempest Reference Manual.

Advertising