Protocol print, Memory print (refo 3-d only) – Hach-Lange REFO 3_REFO 3D User Manual
Page 16
Operating Instructions REFO 3 / REFO 3-D
15
CAL:
Calibrationvalues, standard number is printed, too
Nr.:
ordinary single- or three-angle measurement
M:
mean value
S:
standard deviation
VK:
coefficient of variability
Nr.
R:
reference value
Nr.
d:
difference measuring value
Nr.
dM:
difference measuring value for statistics function
dM:
mean value of difference measurement
dS:
standard deviation of difference measurement
Nr.
RM:
Nr.
reference value for statistics function
RM:
mean value of reference measurement
RS:
standard deviation of reference measurement
RVK:
coefficient of variability of reference measurement
C9.1 Protocol Print
For continuous printing of all values, procede as follows:
•
Connect the printer properly (see chapter B2.4 and printer handbook)
•
Measure
Note: If you want do not want toprint, unplug the printer cable from REFO 3-D.
C9.2 Memory Print (REFO 3-D only)
To print the complete memory, procede as follows:
•
Connect the printer correctly (see chapter B2.4 and printer handbook)
•
Select program P7 with the program key
•
Press the angle selector key to start printing
The printing can be interrupted by pressing the angle selector key. The LF-key is the
line feed key.