INSTEON iMeter Solo (2423A1) Manual - Manual (Page 5)

iMeter Solo Owner’s Manual
Page 5 of 10
Product Use Restrictions
Use only as directed in the instructions and within the specifications and environmental conditions below.
Using iMeter Solo in a different manner may defeat the safety features and protection against electrical
shock and fire.
• 120 Volts AC +/- 10%, 60 Hertz, 15 Amps maximum continuous
• Indoor use only
• Temperature 41° to 104° F (5° to 40° C)
• Maximum relative humidity 80% for temperatures up to 87° F (31° C) decreasing linearly up to
50% relative humidity at 104
° F (40° C)
• Altitude up to 6,500 feet (2,000 meters)
• Installation Category II
• Pollution Degree 2
Installing iMeter Solo
1) Plug the desired appliance into the outlet on iMeter Solo
2) Plug iMeter Solo into an unswitched outlet
iMeter Solo will beep and its Status LED will turn on solid green
After about 20 seconds, iMeter Solo will beep again
USING iMETER SOLO TO MEASURE POWER CONSUMPTION OF
YOUR HOUSEHOLD APPLIANCES
Adding iMeter Solo to HouseLinc
1) In HouseLinc, click the icon and then click the Auto Link
tab. Then, click Start.
The Linking time remaining: countdown will begin
2) On iMeter Solo, press & hold the Set button until it beeps (3
seconds)
iMeter Solo will display in the Auto Link list in
HouseLinc
3) In HouseLinc, click OK
iMeter Solo will appear in the Devices list
HouseLinc will begin synchronizing with iMeter Solo