King Technology POOL FROG XL PRO - Manual (Page 12)

12
1.
2.
3.
4.
5.
1.
2.
3.
POOL FROG
®
Cycler Maintenance
Replacing the Control Dial O-Rings
Using a needle nose pliers,
find the snap ring tail located
at approximately the five
o’clock position under the
control dial.
Pull down and out of the
groove.
Using a large screwdriver,
loosen the control dial.
Carefully pry the dial until it
pulls out.
Carefully replace the rubber
o-ring without stretching it.
Apply silicone lubricant, that
came with your POOL FROG
XL PRO®, on o-ring.
Push control dial completely
into the housing and turn the
dial to setting 2.
Replacing Cap O-Ring
Lubricate o-ring often with
silicone lubricant that
came with your POOL FROG
XL PRO®. DO NOT USE
petroleum based lubricants.
Replacing Knobs
Replace knob in back or on cap
of both POOL FROG XL PRO
®
Cyclers by unscrewing old one
and screwing in new one.
Hold cap in front of you
upside down with the o-ring
groove facing up. Place one
end of o-ring into cap groove
at the point closest to you.
Hold o-ring down with the
thumb and index finger of
one hand.
Take hold of the far end of
the o-ring with the thumb
and index finger of the other
hand. Roll o-ring slightly
back towards you as you
stretch the o-ring into the
remainder of the cap groove.
12
Insert the non-lipped end
of snap ring into the groove
opening beginning at the
5 o’clock position and push
it up so that it threads itself
around the control dial.
6.
7.
Using a small screwdriver or
pointed tool to help guide it,
make sure the snap ring stays
in the groove as it is inserted.
Back of Cycler
Or top of cap
SILICONE
LUBRICANT
SILICONE
LUBRICANT