King Technology POOL FROG XL PRO - Manual (Page 5)

5
®
B R AN D
Start-up and Operation
1.
2.
3.
4.
6.
Add a stabilizer or conditioner to the
pool at the beginning of the season
if the stabilizer level is below 20
ppm. This will prevent chlorine burn
off. Follow manufacturer’s directions
carefully.
Shock the pool with chlorine to rid the
water of all contaminants before begin-
ning with POOL FROG XL PRO®. Follow
manufacturer’s directions carefully.
THIS STEP IS VERY IMPORTANT TO
START-UP.
USE CHLORINE SHOCK ONLY.
Skimmer
POOL FROG®
Mineral Cycler
POOL FROG®
Chlorine Cycler
Do not add shock in or near the skimmer or into the POOL
FROG XL PRO® Cyclers as it could damage equipment, risk
potential explosion or discolor your pool surface.
Install a POOL FROG®
Mineral Reservoir into
the POOL FROG® Mineral
Cycler. (Follow directions
on page 7.)
REPLACE THE POOL
FROG® MINERAL
RESERVOIR EVERY
6 MONTHS OR AFTER
ONE POOL SEASON
WHICHEVER IS SHORTER.
POOL FROG®
Mineral Cycler
POOL FROG®
Chlorine Cycler
POOL FROG®
Mineral
Reservoir
POOL FROG®
Mineral Cycler
POOL FROG®
Chlorine Cycler
POOL FROG®
Mineral Cycler
POOL FROG®
Chlorine Cycler
FROG
BAM
®
When chlorine reading
is down to 1.0 ppm
(which may take a few
days) insert a POOL
FROG® Pac into
the POOL FROG®
Chlorine Cycler.
(Follow directions on
page 9.)
For an Algae Protection
Guarantee insert FROG
BAM® into POOL FROG®
Mineral Reservoir in
POOL FROG® Mineral
Cycler. (Follow directions
on page 8.)
Replace cap and run
POOL FROG® Mineral
Cycler, with POOL FROG®
Mineral Reservoir
inserted, for 10 minutes
on Setting MAXIMUM.
5.
® BR AN D
PAC 540C
POOL FROG ®
Mineral Cycler
POOL FROG ® Pac
®
B R A N D