King Technology POOL FROG XL PRO - Manual (Page 8)

8
®
B R AN D
7.
8.
9.
Using FROG BAM
®
for an Algae Protection Guarantee
If you are not using FROG BAM, proceed to Step 15.
See FROG BAM® product labeling for complete directions
for use (EPA Reg. No. 53735-9). For a preventive dose add:
• One FROG BAM® for pools up to 15,000 gallons.
• Two FROG BAM® for pools between 15,000 and 30,000 gallons.
*NOTE: I f using directly after a shock treatment, test the water first to ensure the pH is in the proper range of 7.2-7.8 and the chlorine
level is no more than 4.0 ppm. Avoid using other chemicals until this product has been circulated (filtered) for at least 24 hours.
Remove cap from
FROG BAM® without
removing seal.
seal
Insert upside down into
center of POOL FROG®
Mineral Reservoir
pushing down firmly on
key to puncture seal.
Replace cap by hand only.
DO NOT OVER TIGHTEN.
Turn control dial on POOL
FROG® Mineral Cycler to
Setting MAXIMUM.
Turn pump on for
90 minutes allowing
FROG BAM® to circulate
through pool.
To remove FROG BAM®,
turn pump off. Turn dial to
Setting 0.
Remove POOL FROG®
Mineral Cycler cap.
NOTE: If water shows
more than a hint of blue
inside POOL FROG®
Mineral Cycler, replace the
cap, turn dial to
Maximum and run the
pump for one minute
14a. If pool size requires
additional FROG BAM®,
repeat steps 7-14.
14b. When water is clear
in POOL FROG® Mineral
Cycler, proceed to insert-
ing POOL FROG® Pac.
Lift FROG BAM® up and allow any water in the
container to drain through the POOL FROG®
Mineral Cycler before discarding in trash.
11.
12.
13.
10.
14.
POOL FROG®
Mineral Cycler
POOL FROG®
Chlorine Cycler
FROG
BAM
®
®
B R AN D
POOL FROG®
Mineral Cycler
POOL FROG®
Chlorine Cycler
FROG
BAM
®