KT&C KVR-H Series - Manual (Page 47)

47
[1] CH : Motion detection ON/OFF selection.
[2] Sensitivity : Sensitivity setup.
Before your actual record appliying, please test the response as per the different
sensitivity.
[3] Detection Area
The cursor moving by the direction key and if press “enter”, this block is designated for
motion detection.
* MD selected area : Blue out-line
* MD non-selected area : transparent
* If the movement is detected, the color of that area turns red.
[Apply to all] If you use the following key, you can make apply or release in one button.
“No1” button: Select all.
“No 2” button: Release all
[Using mouse]
Locate the pointer on start point and click the right button then dragging to the ending
point.