CTEK MXTS 70 - Manual (Page 2)

4 • EN
ChARGING
For best possible charging of your batteries the voltage and current is
adjustable. In addition to that temperature compensated charging is
selectable. See below how to set the parameters for customized charging.
1. Connect the charger cables to the charger
(see connect the cables)
2. Connect the charger to the battery
(see connect the cables)
3. Connect the charger to the wall socket
The power lamp will indicate that the mains cable is connected
to the wall socket. The error lamp will indicate if the battery
clamps are incorrectly connected. The reverse polarity protection
will ensure that the battery or charger will not be damaged.
4. Press the MODE-button to select
charging program
5. Press SET-button to set parameters
6. Select voltage
•Display (h) will indicate that voltage ( U ) is selectable
•Display (V) will indicate set voltage
•Press +/- to change
•Press SET-button to confirm
7. Select current
•Display (h) will indicate that current ( A ) is selectable
•Display (A) will indicate set current
•Press +/- to change
•Press SET-button to confirm
8. Select temperature compensation
• Display (h) will indicate that temperature compensation ( ) is selectable
•Temperature sensor lamp will indicate activated temperature sensor
•Press +/- to change
•Press SET-button to confirm
9. Press the START/PAUSE-button to start
charging cycle or press MODE-button to change
charging program
10. Follow the 8-step display through
the charging process
The battery is ready to start the engine when STEP 4 is lit.
The battery is fully charged when STEP 7 is lit.
11. Stop charging at any time by pressing
the START/PAUSE-button
12. Press START/PAUSE-button
to resume charging cycle
SET
A
Ah & info
V
h
1 2 3 4 5 6 7 8
NORMAL
AGM
GEL
AGM
POWER
Ca/Ca SUPPLY
Amp
12V/70A
24V/35A
MXTS 70
START
PAUSE
MODE
FULLy ChARGED
POWER LAMP
ERROR LAMP
TEMPERATUR SENSOR LAMP
REDUCED CURRENT LAMP
START/PAUSE-BUTTON
MODE-BUTTON
NORMAL PROGRAM
DISPLAy (V)
SET-BUTTON
DECREASE BUTTON
INCREASE BUTTON
DISPLAy (h)
DISPLAy (A)
DISPLAy (Ah & info)
SUPPLy PROGRAM
Ca/Ca PROGRAM
AGM/GEL PROGRAM
AGM POWER PROGRAM
READy TO START
20015126D Manual MXTS70, All languages, Print file 003.indd 4 2011-10-11 13:01:26