CTEK MXS 4003 - Manual (Page 9)

9
EN
MAINTENANCE
The charger is maintenance free. Please note that dismantling the charger is not
permitted and will void the warranty. A defective mains cable has to be replaced by
CTEK or by a representative authorised by CTEK. Keep your charger clean. Wipe
it with a soft tissue and mild cleaning liquid. The charger must be disconnected for
cleaning.
EQUIPMENT
The MULTI XS 4003 model is delivered with one battery lead with battery clamps and
one battery lead with eyelet terminals.
TECHNICAL SPECIFICATIONS
Charger model MULTI XS 4003
Model number 1035
Rated Voltage AC 220–240VAC, 50–60Hz
Charging voltage Car/Motorcycle 14.4V, 14.7V, RECOND 15.8V
Min battery voltage 2.0V
Charging current 4A max
Current, mains 1.2A rms (at full charging current)
Back current drain* <1Ah/month
Ripple** Max 240mVp-p and 160mAp-p
Ambient temperature
-20°C to +50°C, output power is reduced
automatically at high temperatures
Cooling Natural convection
Charger type Eight step, fully automatic charging cycle
Battery types All types of 12V lead-acid batteries
(WET, MF, AGM and GEL)
Battery capacity 1.2–140Ah
Dimensions 168 x 65 x 38 mm (L x W x H)
Insulation class IP65***
Weight 0.6kg
*) Back current drain is the current that drains the battery if the charger is not
connected to the mains. CTEK chargers has a very low back current.
**) The quality of the charging voltage and charging current is very important. A
high current ripple heats up the battery which has an aging effect on the positive
electrode. High voltage ripple could harm other equipment that is connected to the
battery. CTEK battery chargers produce very clean voltage and current with low
ripple.
***) If connection to the mains is by the flat Euro connector, the battery charger has
the IP63 insulation class apart from in Switzerland where IP65 applies.