CTI Products EXB-IP Ethernet System Extender - Manual (Page 34)

CTI Products, Inc. EXB-IP User Guide
Hardware Installation 34
Ethernet Connection
• The Ethernet network must be attached to the EXB-IP module via 10BaseT connector.
WARNING: DO NOT connect the EXB-IP modules to a live Ethernet network until they have
been reconfigured with IP parameters supplied by the Network Administrator. Network-wide
problems could arise from connecting devices to a network without coordination of
addressing information.
The 10BaseT port utilizes a standard RJ45 connector. Cat 5
unshielded twisted pair cable should be used between the EXB-IP
module and the hub. The length of this cable should be less than
100 meters (328 feet).
IP Switch Manual Settings Note
Some IP Switches (Like some HP Switches) that have Auto Speed and Duplex negation may not be
able to auto-negotiate with the EXB-IP module. In those cases, we recommend that you manually
configure the Ethernet port in the IP switch that connects to the EXB-IP module. See the IP Switch
Configuration – Speed & HDX/FDX Negotiation section on page 55 for more details.
DC Power Connection
DC power must be attached to the EXB-IP module via the DC IN
connector. Apply DC power to the EXB-IP module only after all
other connections have been made. A wall plug-in style power supply
designed for the EXB-IP module is an available option.
The installation of the EXB-IP module is now complete.
10BASE-T
DC IN