Controlled Products Systems Group RAM3000 - Manual (Page 3)

TABLE OF CONTENTS
Important Safety Requirements & Instructions …………………………………………….........……. 1
Responsibilities of Installers and Technicians …………………………………………………………. 2
Important Safety Requirements by UL Standards…………………………………….……………….. 3
Classes of Vehicular Gate Operators ...………………………………………………………………... 4
General Specifications ………………………………………………………………………………….... 5
Installation Specifications ………………………………………………………………………………... 6
Hookup Electrical Power - Gate Travel Adjustment …………………………………………………... 7
Standard Installation for Gates from 8' to 16' in Length …………………………………………….... 7
Standard Installation for Gates from 16' to 22' in Length …………………………………………….. 8
Space Required for Standard Gate in the Open Position ………………………………………….... 8
Compact Installation and Minimum Space Required …………………………………………………. 9
Sensor Installation ………………………………………………………………………………………..10
Pushbutton Controls & Master/Slave Installation ……………………………………………………..11
Dip Switch Configuration ……………………………………………………………………………. 12-13
Terminal Strip Connections ………………………………………………………………............... 14-15
Ramset "Intelligate" Control Board ………………………………………………………....…………. 16
Wire Board Connections ………………………………………………………………………………... 17
Exploded View Parts Diagram …………………………………………………………………….….... 18
Bill of Materials ………………………………………………………………………………………. 19-20
Troubleshooting Table …………………………………………………………………………….......... 21
Gate Entrance Safety Precautions ……………………………………………………………………. 22
Important Information for The Homeowner………………………………..........……………………. 23
Ramset Optional Accessories …………………………………………………………………………. 24
IMPORTANT SAFETY REQUIREMENTS & INSTRUCTIONS
WARNING To reduce the risk of injury or death:
1. READ AND FOLLOW ALL INSTRUCTIONS.
2. Never let children operate or play with gate controls.
Keep the remote control away from children.
3. Always keep people and objects away from the gate.
NO ONE SHOULD CROSS THE PATH OF THE MOVING
GATE.
4. Test the Vehicular Gate Operator monthly. The gate
MUST reverse on contact with a rigid object or stop
when an object activates the non-contact sensors.
After adjusting the limit of travel, retest the Vehicular
Gate Operator. Failure to adjust and retest the
Vehicular Gate Operator properly can increase the
risk of injury or death.
5. Use the Emergency Release only when power switch
or circuit breaker has been turned off. Using the Emer-
gency Release during a power failure can be a
hazard if power is abruptly restored.
6. KEEP GATES PROPERLY MAINTAINED. Read the
Owner’s Manual. Have a qualified service person
make repairs to gate hardware.
7. The entrance is for vehicles only. Pedestrians must
use separate entrance.
8. SAVE THESE INSTRUCTIONS.
WARNING:
Do not install this gate operator if you do not have experience or appropriate
training with gate operators.
1 www.ramsetinc.com
RAMSET
R
AM 3
000 U
L
- 3100 U
L
- 3200 U
L
R_Ramset_Ram3000.qxd 8/19/05 4:56 PM Page 3