Controlled Products Systems Group STRONGARMPARK DC 10 - Manual (Page 45)

www.hysecurity.com SDC Inputs & Wiring D0536 Rev. B 4-5
Label SDC Terminal Wire Connections Commonly used for...
EYE OPEN Eye Open Spare input for StrongArmPark DC
only. N.O. input for SlideSmart DC &
SwingSmart DC. Connection for Photo
Eye Open direction. Can be changed
to a monitored Normally Closed (N.C.)
contact through the Installer Menu Non-contact entrapment sensors.
EYE
CLOSE Photo Eye Close
direction N.O. input. Connection for Photo Eye
Close direction. Can be changed to
a monitored Normally Closed (N.C.)
contact through the Installer Menu. Non-contact entrapment sensors.
EXIT
LOOP Free Exit Vehicle
Detector N.O. input. Connection for free exit
vehicle detector. Vehicle detector, box type
connections for free exit loop.
BLOCK
EXIT Block Free Exit
vehicle detector or
Close Timer N.O. input. Free Exit is only disabled if
Close Limit Switch is tripped. Installer menu enabled. See DT 0
If the gate is partially opened,
the Free Exit detector will trigger
the gate to open fully. The input
can be converted in the Installer
Menu to alternately disable the
Close Timer.
IN OBS
LOOP Inside Obstruction/
Arming Vehicle
Detector N.O. input. Inside reversing loop. Vehicle detector, box type
connections inside reversing loop
OUT OBS
LOOP Outside Obstruc-
tion/Arming Vehicle
Detector N.O. input. Outside reversing loop. Vehicle detector, box type con-
nections outside reversing loop
CENTER
LOOP Center Loop
(Shadow) Vehicle
Detector N.O. input. Center Loop for
StrongArmPark DC. Shadow function
used for Swing gates only. Vehicle detector, box type con-
nections. Shadow function for
swing gates, reset function for
barrier arm gates.
EDGE Edge Sensor N.O. input. One input works for both
directions of travel. It can be changed to
N.C. contact through the Installer Menu. Gate edge, entrapment device
sensor connections. One input
works for both travel directions.
EYE
COM Photo Eye Common When the Photo Eye Open and
Photo Eye Closed common wires are
connected to this terminal, the photo
eyes energize only when the motor runs.
Photo eye connections.
Use these terminals to preserve
battery power.
+ 24 +24V DC 24VDC power. Convenient 24VDC power for
photo eyes or the Emergency
Open input.
EMERG
OPEN Emergency Open
(Fire Dept.Open) ** N.O. input. The Emergency Open must be
enabled via the Installer Menu.
It is energized by connecting to
the +24V terminal above it. The
EMERG OPEN overrides photo
eye & edge sensor commands.
* Do not connect an external control to the STOP or OPEN inputs unless the controls are located in clear view
of the entire gate area. Use the RADIO OPEN input or RADIO OPTIONS spade connections for all out-of-sight
controls, such as a telephone entry or radio operated controls.
**The Fire Department Open control must be keyed or guarded so that it can only be used by authorized
personnel.
SDC Inputs
COM
COM
COM
COM
COM
COM
COM
COM
STOP
OPEN
RADIO
CLOSE
OPEN
OPEN
PARTIAL
EYE
OPEN
EYE
CLOSE
EXIT
LOOP
BLOCK
EXIT
IN OBS
LOOP
OUT OBS
LOOP
CENTER
LOOP
EDGE
EYE
COM
+ 24 V
EMERG
OPEN
SHOW
LEDs
24VDC
24VDC
24VAC
24VAC
12VDC
12VDC