Acer Altos R300 - Manual (Page 98)

4 BIOS Setup utility 84
Onboard LAN 1
Onboard LAN 2
When you set the PCI IRQ Setting
parameter to Auto, this parameter
specifies the auto-assigned interrupt for
the onboard LAN controlers installed in
your system.
When you set the PCI IRQ Setting
parameter to Manual, you need to specify
the interrupt that you want to assign for
the onboard LAN controllers installed in
your system.
User input
Onboard VGA When you set the PCI IRQ Setting
parameter to Auto, this parameter
specifies the auto-assigned interrupt for
the onboard VGA controller installed in
your system.
When you set the PCI IRQ Setting
parameter to Manual, you need to specify
the interrupt that you want to assign for
the onboard VGA controller installed in
your system.
User input
PCI IRQ Sharing Setting this parameter to Yes allows you to
assign the same IRQ to two different
devices. To disable the feature, select No.
Note: If there are no IRQs available to
assign for the remaining device function,
it is recommended that you enable this
parameter.
Yes
No
Parameter Description Option
aa r300.book Page 84 Tuesday, March 11, 2003 9:42 AM