Laurel Electronics Modbus Protocol For Series 2 Laureate Digital Panel Meters, Counters, Timers & DIN-Rail Transmitters - Manual (Page 23)

- 23 -
READ ONLY (FC03) – Data Type B16
100 0064 Analog Output
DAC Type Bits 7:0 0 = none,
1 = 1 output, unipolar (12-bit, pre 2009)
2 = 1 output, unipolar (16-bit, pre 2009)
3 = 1 output, uni or bipolar (16-bit, post 2009)
4 = 2 outputs, unipolar (16-bit, post 2009, not
for Scale Meter)
101 0065 Device Type Bits 7:0 01 = DPM meter 02 = Scale meter
03 = Counter/timer met. 05 = DPM transmitter
06 = Scale transmitter
07 = Counter/timer transmitter
102 0066 Revision Bits 7:0 Hex value of Decimal Revision number
103 0067 Overload Value Bits 7:0 Hex overload value
104 0068 Signal Condi-
tioner Type Bits 7:0 01 = DC, TC/RTD (pre 2009)
02 = RMS (pre 2009)
03 = Load Cell
22 = RMS (post 2009)
31 = TC (post 2009)
41 = RTD or Ohms (post 2009)
WRITE ONLY (FC10 dec16) – Data Type 2C32
105 0069 Display Data (Hi Word) Hi word of Remote Data to be displayed.
106 006A Display Data (Lo Word) Lo word of Remote Data to be displayed.
13. COUNTER / TIMER REGISTER ADDRESSES FC03 & FC10 (dec16)
Data Types - as shown
Use high word starting Register Addresses and an even number of Registers.
Register Address
Dec* Hex*
Register Name
Data
Type
Scaling & Decimal Point
1
2
3
4
5
6
7
8
9 0001
0002
0003
0004
0005
0006
0007
0008
0009 Setpoint 1 (Hi word)
Setpoint 1 (Lo word)
Setpoint 2 (Hi word)
Setpoint 2 (Lo word)
Setpoint 3 (Hi word)
Setpoint 3 (Lo word)
Setpoint 4 (Hi word)
Setpoint 4 (Lo word)
Scale 1Y (Hi word) 2C32
2C32
2C32
2C32
2C32
2C32
2C32
2C32
M32
Dec point same as displayed.
Dec point same as displayed.
Dec point same as displayed.
Dec point same as displayed.
Scale = .00001 x dec value