Lectrosonics Venue (Narrowband) - Manual (Page 10)

Venue Narrowband Receiver
Powering On and Off
When the Venue receiver is first powered up the LCD
will show the firmware revision and the tuning range
of the host assembly for a few seconds as the boot
sequence begins.
The receiver modules are then detected, which takes a
few seconds.
When detection is complete, the LCD will briefly display
the frequency blocks of the installed modules.
At the end of the boot sequence the LCD changes to an
overview screen of all six channels.
In this example of the overview screen, six receiver
modules are installed, but no transmitters are in use.
During operation, the overview screen will display the
following information for the channels in use:
• Audio level
• RF level
• Diversity antenna phase activity
• Pilot tone status
• Transmitter battery status
Diversity activity
Audio level (in switched mode)
No module
installed in
channel 6
Pilot tone status RF level
Transmitter
battery gauge
In this example, channels 1 and 4 are being used; chan­
nels 2, 3 and 4 have a receiver module installed, but the
matching transmitters are not turned on. Channel 6 has
no receiver module installed.
To turn the power off, press and hold the red power
switch for several seconds. The LCD will display a mes­
sage briefly then power down.
Navigating the LCD Menus
and Screens
Front panel controls provide access to screens and
menus for setup. The Function Button, Back Button, Re­
ceiver Select buttons and the MENU/SELECT control
are used to make selections and adjust parameters.
Function Button (labeled by the LCD)
Back Button Receiver Select MENU/SELECT
Buttons 1-6 Control
The overview screen displays a summary of all six
channels, as shown above. This is a good starting point
for navigating to any menu or setup screen. Pressing
the BACK button repeatedly from any menu or screen
will eventually return to this overview screen.
From the overview screen, pressing one of the six
Receiver Select Buttons will switch to the detail screen
for the associated receiver module to display all current
settings, levels and status.
Pilot Tone Transmitter Frequency
Monitoring Status Select Switch Settings
Receiver Module Operating
Location Frequency
RF Signal
Strength
Antenna Phase Tuning Mode
Transmitter
Battery Gauge
TV Channel
Audio Level Meter
LECTROSONICS, INC. 10