Lectrosonics Venue (Narrowband) - Manual (Page 11)

Digital Hybrid Wireless™ Modular Receiver System
Pressing the Receiver Select Button again will switch
to the receiver module information screen to show the
basic setup.
Press the BACK button twice to return to the overview
screen.
From the overview screen, press the MENU/SELECT
control to open the TopMenu, rotate the control to
select an item, then press the control to enter the setup
screen for that item.
In a setup screen such as the LockSet example shown
here, up/down arrows prompt you to change the setting
by rotating the MENU/SELECT control.
Up/Down
Arrows
When the desired setting or value is displayed, press
the MENU/SELECT control or BACK button to return to
the previous menu.
Selecting SetUpRx (set up receiver) in the TopMenu
will take you to another menu where all settings for the
receiver modules can be made.
Select an item with the MENU/SELECT control and
press the control to open the setup screen (“Level” in
this example).
Setup screens for the receiver modules display the
settings for the selected module and allow immediate
access to all modules by pressing the Receiver Select
Buttons. Receiver module 1 (Rx1) is selected in this
example with its output level set at -3 dBu.
Function
Button
If another option is available, it will appear in the left
hand section of the LCD (“TONE” in this example).
Press the Function Button to select and deselect this
option with repeated presses. The display will highlight
the option when it is selected.
NOTE: Settings take effect immediately and are
stored until changed again. Pilot Tone Bypass is
different in that it resets to the default value when
the power is cycled.
Please spend a few minutes with the navigation controls
to familiarize yourself before going through the setup
procedures. Details for each adjustment and setting
begin on the next page.
Resetting to Factory
Defaults
Resetting to Factory Defaults can be a time saver for
setting up the system. Start with the power turned off,
then hold Receiver Select Buttons 5 and 6 while power­
ing up the system.
POWER Switch
Receiver Select
Buttons 5 and 6
The Factory Default Settings are:
Level +00 dBu
Phase NORMAL
TxBatt 9V ALK
SmartNR NORMAL
Compat Dig. Hybrid
Tuning NORMAL MODE
DivMode Switched
LockSet NOT LOCKED
RxCh 8,0
Rio Rancho, NM, USA 11