Lectrosonics UT200c - Manual (Page 10)

ADJUSTING THE TRANSMITTER FREQUENCY
If you are experiencing interference from another signal on your frequency, you may want to change the operating
frequency of your system. The switch nearest to the mic element changes the operating frequency by 100 kHz per
step and the switch furthest from the mic element changes it 1.6 MHz per step. If you are experiencing interference,
change the operating frequency of the receiver to find a clear channel, then set the transmitter to match.
Note: These switches also appear on the front panel of the
UDR200A version of the studio receiver and on the rear panel of
the UCR200D version of the compact receiver. Normally, you
should set the transmitter switches to match the receiver switch
settings.
With the UDR200B version of the studio receiver, the front panel 1.6M 100K
LED character display will indicate the correct transmitter switch
Frequency Switches
settings.
To gain access to the Frequency Switches, pull the access door straight out. It is held in place magnetically. There is
a “doorknob” provided for gripping.
Frequency Switches
100 kHz 1.6 MHz
Magnetic Door
Door Knob
UT200C Internal Controls
10