Specifications – Lectrosonics UT200c User Manual
Page 12
SPECIFICATIONS
Operating Frequencies:
537.600 to 607.900 MHz
614.100 to 767.900 MHz
RF Power Output:
100mW
Pilot Tone:
32.765 kHz, ±2 Hz, 5kHz deviation
Frequency Stability:
±0.002%
Deviation:
± 75 kHz max
Spurious Radiation:
Effectively none below 1GHz, above 1GHz At least 50dB
below the carrier
Equivalent Input Noise:
–126 dBv
Input Level:
Maximum SPL depends on mic element used
Input Compressor:
Soft compressor, >30 dB range
Gain Control Range:
43 dB, semi-log rotary control
Modulation Indicators:
Dual LEDs indicate modulation level 10 dB below clipping
and at the onset of limiting
Controls:
Power ON/OFF, Audio ON/OFF and Battery Condition LED
located on bottom of unit; Bypass controls located inside
battery door
Gain control located inside battery door; Frequency switches to
adjust the transmitter frequency in 1.6 MHz and 100 kHz increments located just
below the mic head on the outside body of the case.
Battery
Precision compartment auto-adjusts to accept any known
alkaline or lithium 9 Volt battery. (We’ve tried over 150 different ones!)
Weight:
13.2 ozs. with VariMic capsule and alkaline battery
Dimensions:
9" long x 2.05" diameter (at largest point) with VariMic capsule
Emission Designator:
200KF3E
Specifications subject to change without notice.
The UT200C transmitter is FCC type accepted under part 74:
UT200C Emission Designator: 180KF3E
12