Software installation, Refer to the help files, Creating an aspen installer disk – Lectrosonics SPNTWB User Manual
Page 11
Installation and Startup Guide
Rio Rancho, NM
11
Software Installation
NOTE: Uninstall any previous version before
installing the software.
ASPEN Control Panel software can be installed from
the disk supplied with each processor, or from files
downloaded from the ASPEN Support web site.
Installation is straightforward and requires no special
instructions.
The downloaded
ASPEN Control Panel Installer will
automatically install the USB driver, GUI and Help files.
The disk supplied with the processor has separate
installers. Make sure you have at least the USB driver
and control panel GUI installed.
The Welcome screen appears first with a brief message
about closing other programs before installing. Click
Next to continue.
The next screen displays the
License Agreement.
Click on I Agree to continue.
The third screen displays an option to select the desired
installation. It is best to check all three boxes so the
the USB driver, Control Panel and Help utility will all be
installed.
Follow the on-screen prompts to complete the installa-
tion. On the last screen, click
Finish to exit the installer.
Refer to the Help Files
Once the processors are installed, configured and com-
municating with a computer system, refer to the Help
files in the software ASPEN Control Panel program for
additional information regarding the available settings,
adjustments and control.
Creating an ASPEN
Installer Disk
If you do not have the disk supplied with the processor,
go to the web site and download the ASPEN Installation
Disk .iso file.
Save the file to your local drive in a familiar location.
Open a disk copier utility such as Roxio Classic and
select the operation to Burn from a Disk Image File.
NOTE: The .iso file cannot be simply copied to the
disk. The disk recording utility must run a process
that creates a disk from a stored image file.
The .iso file format is recognized by almost any disk
creation software.