Lectrosonics SPNDNT - Manual (Page 11)

Installation and Quick Start Guide
Rio Rancho, NM 11
Mandatory Settings
Set up the system in the Switched Mode in the Net-
work Config screen in Dante Controller. Once every-
thing is set up and audio is flowing to and from the
network, a second network and gigabit switch can be
added and the mode can be changed to Redundant.
Connect an SPNDNT Dante port to the computer either
directly or through a gigabit switch.
Dante Primary Port
Connect the PC to the Primary Port in case the mode
had previously been set to Redundant. Confirm that
the 1G and LINK/ACT LEDs next to the Dante port are
flickering.
Launch the Dante Controller software. A brief splash
screen appears, followed by the Network View/Routing
screen. The serial number of the connected processor
will appear in the bars labeled Receivers and Trans-
mitters.
Processor name and
serial number appear in
the blue bars
Double click on either blue
bar to open the Device View
dialogue box
Double click on the processor name/serial number to
open the Device View dialog box. Under the Network
Config tab, select Switched.
Select
Network
Config
Select
Switched
Select the Device Config tab, then set the sample
rate to 48k. The sample rate MUST be 48k so the DSP
(filters, etc.) will operate as they should.
Device Config Tab
Select 48k Sample Rate
Latency under the same tab can be adjusted depend-
ing upon the number of switches in the network.
The other tabs in the Device View dialog box are used
to rename channels and check the status of several
parameters.
Consult the
Help menu for details and explanations of
Dante Controller software.
Made In the USA