Lectrosonics SPNDNT - Manual (Page 15)

Installation and Quick Start Guide
Rio Rancho, NM 15
100-240V
50/60Hz 30W
ASPEN PORTS
ETHERNET RS-232
SPN 1624
OUTPUTS INPUTS
OUTPUTS INPUTS
GND
+5V PROG IN
PROG
OUT
GND
PROG IN +5V
PROG
OUT
Adaptive Proportional Gain Mixing
US Patent 5,414,776
S/N LABEL
DATECODE
Secondary network for redundancy
RS-232 ports for external control system
Network Audio Transport
Supplied ASPEN cables
CAT-5 or better
cables
CAT-6 cable
Ethernet switch
OR
(optional)
To front panel
USB port
Using Switched and Redundant Modes
NOTE: See page 11 for instructions on
selecting the mode using Dante Controller
software.
Set processors to the Switched mode for setup.
In the Switched mode, the Primary and Sec-
ondary ports can be connected in any combi-
nation since there is an ethernet switch in the
hardware.
In the
Redundant mode, the Primary ports on
all processors must be connected to the first net-
work and the Secondary ports on all processors
must be connected to the second network.
After all connections and settings are completed
and the system is passing audio through the net-
work, connect the second network and set the
processors to the Redundant mode.
These connections
are for setup and
control with ASPEN
Control Panel
software.