Lectrosonics SPNDNT - Manual (Page 14)

ASPEN Digital Processor
LECTROSONICS, INC. 14
100-240V
50/60Hz 30W
ASPEN PORTS
ETHERNET RS-232
SPN 1624
OUTPUTS INPUTS
OUTPUTS INPUTS
GND
+5V PROG IN
PROG
OUT
GND
PROG IN +5V
PROG
OUT
Adaptive Proportional Gain Mixing
US Patent 5,414,776
S/N LABEL
DATECODE
Network and PC
Connections
The SPNDNT processor must be the Master at the top
of the ASPEN stack to synchronize the system and
network clocks.
Gigabit ethernet switch
Gigabit ethernet switch
Network Audio Transport
Audio I/O
Audio I/O
These connections
are for setup and
control with ASPEN
Control Panel
software.
Supplied ASPEN cables
RS-232 ports for
external control system
CAT-5 or better
cables
Network Audio Transport
Server
CAT-6 cable
Ethernet switch
OR
(optional)
To front panel
USB port
Using DHCP for IP Address Assignment
Follow these steps to make a network connection for
each processor:
1) Open the ASPEN Control Panel program and
connect to the processor via USB.
2) Click on the Device Settings tab (lower left)
then on the Network tab (left side). Click the
checkbox to enable DHCP.
3) Close the ASPEN Control Panel program.
4) Connect the network cable to the Ethernet port
on the rear panel.
5) Turn the processor power off then back on.
6) Open the ASPEN Control Panel program and
connect to the processor via USB.
7) Navigate to the Device Settings/Network tab
and make a note of the IP address and TCP
port number.
8) Close the USB connection and re-connect via
network. When the dialog box opens, enter the
IP address and the port number noted, then
click on Refresh. Click on the processor icon to
connect.
PC