Lectrosonics SPNDNT - Manual (Page 7)

Installation and Quick Start Guide
Rio Rancho, NM 7
USB Driver Installation
The ASPEN USB drivers are installed from the ASPEN
Installation Disk, which comes with each device, by
running the ASPEN Device Installer. Normally this is
done before connecting an ASPEN device to the PC
for the first time, but it can be done afterwards if neces-
sary. The driver installation only needs to be done once
on each PC that will be connected to an ASPEN unit.
If an ASPEN device is connected to a PC without prior
installation of the drivers from the ASPEN Installation
Disk, manual installation is possible for Windows XP
and Vista operating systems using the New Hardware
Found wizard. In the case of Windows 7, there is no
New Hardware Found wizard, so manual installation is
a bit more involved. In any of these cases it’s not really
necessary if you have the installation disk. Just cancel
the New Hardware Found wizard (if open) and run the
ASPEN Device Installer from the Installation Disk.
Installation with ASPEN Device Installer
Place the ASPEN Installation Disk into the CD-ROM
drive. If “AutoRun” is enabled on that drive then the
ASPEN Installation Disk utility will open. Click on
Install ASPEN Software/USB Drivers.
Note: If AutoRun is not enabled use Start->Run
to run “autoRun.exe” on the drive holding the
ASPEN Install Disk. For example, if the CD-ROM
drive is drive E: then run “E:\autoRun.exe” to
open the ASPEN Software CD utility.
On the next screen, select the correct driver for your
operating system (32-bit or 64-bit).
32-bit Drivers
64-bit Drivers
The ASPEN Device Installer opens.
Click Next to proceed.
The End User License Agreement is presented.
Accept, then click Next to proceed.
The drivers are installed from the CD.
When installation is complete, the Driver Name and
Status are displayed. Click Finish to close the Device
Installer.