Magnum Venus Plastech PATRIOT 1-1_4 PAT-LS-12270 - Manual (Page 23)

PAT-LS-12270 Series Fluid Section Manual
Rev. 01/2012 Page | 23
• Outlet Body Assembly –
1. Properly clean Outlet Body, lightly lubricate the thread and seal areas with Red
Grease (6706-2-1 1oz.)
2.
Lightly lubricate the Rod Seals with Red Grease and install the first Rod Seal into
the top of the Outlet Body with the O-Ring facing down.
3. Repeat the process for the second Rod Seal. For systems with a single Rod
Seal go to the next step.
4. Check the Rod Bushing for wear or damage replace as necessary. Lightly
lubricate with Red Grease and install it into the Packing Nut.
5. Screw the Packing Nut and Rod Bushing into the top of the Outlet Body just so
that it makes contact with the Piston Seal.
NOTE: Some versions of the fluid section have only one Rod Seal.
NOTE: Do not use any grease in the DUO Fluid Sections (PAT-LS-12270-D).
NOTE: See below for special instructions to assemble the Outlet Body for
the Fluid Section (PAT-LS-12270-GL).