Magnum Venus Plastech Flex Molding Process PPVS-INFUSION VACUUM - Manual (Page 18)

PPVS Vacuum Sensor Manual
Rev. 03/2013 Page | 18
PVS-INFUSION Valve Mode Overview:
OFF Mode – No air supplied to the Start / Air Supply port of the valve. The valve is inactive.
On / Start Mode – by applying an air signal to the Start / Air supply signal port the valve
will become active and when the vacuum level reached the set point the valve will send
an air signal to do something - Close the IVX3 or TAS.
Active Mode – When the PPVS is On and monitoring the vacuum level and the vacuum
level reaches the set point the valve will become active and send an air signal through
the Red 4mm tube to do something - Close the IVX3 or TAS