Magnum Venus Plastech Megaject RTM Pro Revison 7_0 - Manual (Page 7)

Megaject RTM Pro Manual – Revision 7.00 – 13
th
APRIL 2006
Figure 1.2 illustrates the main electrical isolator, power and air connections for the
Megaject RTM Pro. These are located on the side of Bay 1.
Figure 1.2 – Electrical isolator and service connections
Above the electrical isolator, towards the top of the machine, is the panel shown in
Figure 1.3. A connector is provided to allow an external resin level sensor to be
connected to the machine in addition to an Ethernet socket, which allows a PC to
connect to the control system. The blue RESET button is used for the safety circuit,
and must be pressed when the machine is first powered-up, or after an emergency stop
condition, when the e-stop button has been released.
Figure 1.3 – Reset button and external connections
Bay 2 contains the resin pump, catalyst pump, progressive catalyst ratio system and
pneumatic control and preparation components, and is shown in Figure 1.4.
E-Stop RESET
Button
Resin level sensor connection
Ethernet socket
Power indicator
Isolator switch
Electrical supply
Air supply