Magnum Venus Plastech PRO AND SUPER PRO CHOPPER VRC-1000_2000_3000 - Manual (Page 18)

Pro & Super Pro Chopper Manual
Rev. 02/2013 Page | 18
8. Fill all the slots on the rotor with the spring, retainer, and blade subassembly.
CAUTION: Be sure the rotor is positioned correctly.
9. The rotor must be positioned so that, as it rotates clockwise, the retainer and
spring contact the rubber roll before the blade does, (blade hits last).
10. Slide the rotor onto the air motor shaft so that the set screws align with the flat on
the air motor shaft. Adjust the rotor so that the blades should align with the
rubber roll.
11. Secure the rotor by tightening the set screws.
Reinstall Chopper Cover
1. Attach the cover to the chopper, aligning the base plate’s notch with the boss in
the cover. Twist the cover stud to lock the cover in place.
WARNING: Never operate the chopper unless the cover is installed, or personal
injury may result.
Reinstall Glass
1. Thread the glass strands through the brake guides on the boom.
2. Bend the end of a strand of glass to form a small loop.
3. Insert the loop into a hole in the chopper cover.
DANGER: Be sure all air to chopper is disconnected to prevent accidental injury.
DANGER: BLADES ARE SHARP. To prevent injury, insert fingers carefully.
4. CAREFULLY insert your finger into the chopper, and then rotate the rubber roll
by placing your finger under the roll and pulling your finger toward you. This pulls
the glass strand into position between the rubber roll and the blade rotor
assembly.
NOTE: Using two strands of glass results in a better glass pattern and less wear
on the chopper unit.