Magnum Venus Plastech PRO AND SUPER PRO CHOPPER VRC-1000_2000_3000 - Manual (Page 30)

Pro & Super Pro Chopper Manual
Rev. 02/2013 Page | 30
Rubber Roll Adjustment
1. Slightly loosen the Socket Head Cap Screw (7102-2-20), just enough so the
Rubber Roll Assembly will slide in the T-Slot.
2. Apply slight pressure of the Rubber Roll Assembly to the Wedge Rotor Assembly
(5103-03-01), and tighten the Socket Head Cap Screw (7102-2-20).
NOTE: When making this adjustment, Rubber Roll must not be in contact with
chopper blade.
Idler Adjustment
1. Slightly loosen the Socket Head Cap Screw (7102-2-20), just enough so the Idler
Assembly will slide in the T-Slot.
2. Slide the Sleeve w/ Bearing (5103-7-01) until it just makes contact with the Rubber
Roll (5106-6-1).
NOTE: Proper adjustment has Idler Assembly touching the Rubber Roll, but still
able to rotate with minimum effort.