Magnum Venus Plastech PRO AND SUPER PRO CHOPPER VRC-1000_2000_3000 - Manual (Page 28)

Pro & Super Pro Chopper Manual
Rev. 02/2013 Page | 28
Super Pro Cutter:
NOTE: This chapter pertains to the disassembly and assembly of the rubber roll
and rotor assemblies.
Introduction:
The SuperCutter uses different rotor assemblies from the Pro Chopper and they are
only available in a Wedge style. The Super Cutter Rotor diameter is 1.375” (34.9mm).
Wedge Style Rotor Assembly
Wedge Rotor Assemblies
Part Number Description # of blades Chop Length Optional configurations
5103-04-01 6 Blade Wedge Rotor 6 .72” 2 blade (2.16”) &
3 blade (1.44”)
5103-03-01 8 Blade Wedge Rotor 8 .54” 2 blade (2.16”) &
4 blade (1.08”)
1. Unscrew the Cover Nut (5103-14-1) and remove the Chopper Cover (5103-13-1)
from the Roving Cutter Basic Assembly (5103-00-01).
Rubber Roll Disassembly
2. To remove the Rubber Roll Assembly, loosen the Socket Cap Screw (7102-2-20)
enough to slide the Slide Adjust Nut (5103-4-1) from the slot in the Base Plate
(5301-1-1)
3. With a screw Driver, remove the E-Ring (7205-3-31), and slide the Rubber Roll
(5103-6-1) off the Mandrel Assembly (5403-5-01).