Magnum Venus Plastech PRO AND SUPER PRO CHOPPER VRC-1000_2000_3000 - Manual (Page 24)

Pro & Super Pro Chopper Manual
Rev. 02/2013 Page | 24
Install Sleeve and Bearing (also called the IDLER ROLL)
1. Place the eccentric nut (5113-4-1) into the hole on the base plate.
2. Insert the screw through the sleeve assembly
3. Place the washer (5103-18-1) over the end of the screw.
4. Secure the idler roll to the washer with the screw.
5. Tighten the idler roll by rolling the eccentric nut (5113-4-1) toward the front of the chopper.
Install Chopper Mount
1. Insert the machine screw (F-HB-04C-12) and lock washer (F-SW-04) into the
chopper mount.
2. Insert an eccentric stud (5103-17-1) into the chopper mount.
3. Thread into the gun block and tighten.
4. Place spherical washer (7202-7-1) over the hex cap screw (F-HB-04C-20-GR5).
5. Thread the screw and washer through the hole on the base plate assembly.
6. Place friction washer (5113-6-1) on the other side of the base plate assembly and use
lock nut (F-TLN-04C) to secure the chopper mount and washer to the hex cap screw.
Install Rubber Roll Assembly
1. Press the rubber roll onto the mandrel (5103-5-1).
2. Place the E-ring (7205-3-31) into the groove on the mandrel.
3. From the E-ring side, insert a cap screw (F-HB-04C-24-GR5) through the mandrel
assembly.
NOTE: Make sure that the cap screw is not bent.
4. Place a washer (00201-1) on the cap screw (F-HB-04C-24-GR5).
5. Insert the end of the mandrel assembly through the chopper base plate assembly.
6. Screw the rubber roll & mandrel assembly into the eccentric nut (5113-5-1).
NOTE: Do not tighten the assembly yet.