Luminex xPONENT 4.2 for FLEXMAP - Manual (Page 37)

2. In the Sample Lists section, select the protocol you are using for the sample list, then
click Create New Samples. The Create Sample tab opens.
3. In the ID box, type the sample ID.
WARNING: You will not warned if you create a sample ID that is the same
as another.
4. Type a patient first name in the First name box (optional).
5. Type a patient last name in the Last name box (optional).
6. Type any comments (optional).
7. Click Save to add the sample to the Sample list.
8. To add more samples, click New. Repeat Steps 3-7 until you have added all of the
samples you want in your samples list.
9. Once you have added all the desired samples, click Close.
NOTE: Samples can also be added using an LIS.
Samples Page
23