Axis Communications 230 MPEG-2 - Manual (Page 32)

The System Options AXIS 230 32
Allowed Ports - Check the boxes for the protocols that the user (IP address) will be allowed
to use to access the camera. These can be FTP and/or HTTP. If you have particular
requirements concerning which ports access will be allowed on, enter these in the Port
range fields. To allow access via HTTP, the port value here must correspond to the value
set on the TCP/IP Network Settings page. If this is set to some other value than 80 (the
default setting), then this value must be added manually in this field. If the setting on the
Network Settings page is 80, then nothing needs to be configured here.
After adding the above information click the OK button to save the changes.
Note: If accessing the AXIS 230 via a proxy server, the proxy server's IP address must
be added to the list of allowed IP numbers.
Deleting and Modifying the Properties for Allowed IP Addresses
To delete an IP address, select it in the list and click the Remove button. To modify an
address, select it from the list of allowed addresses, make the necessary changes and then
click OK.
Date & Time
Click Date and Time to define the time and date settings for the AXIS 230, either manually
or automatically, as described below.
Current Server Time
Shows the current date and time.
New Server Time
Time Zone - Select the time zone where the AXIS 230 is located.
Automatically adjust for daylight saving time changes - Check this box to automatically update
the time changes caused by daylight saving.
Synchronize with computer time - Sets the time according to the clock on your computer.
Synchronize with NTP Server - This option will cause the AXIS 230 to update the time from an
NTP server every 60 minutes. Specify the NTP server's IP address or DNS name and set the
appropriate time zone for your camera’s location. Note that if using a DNS name, a DNS
server must be configured in the TCP/IP settings.
Set manually - Using this option allows you to manually enter the time and date.