Micromod Micro-PWC: 53PW6000 MicroPWC Installation and Setup Manual - Manual (Page 29)

Micro-PWC
™ Installation & Setup Guide
Installation 19
1. Prepare to install the Supervisor board as follows.
a. Turn off the computer and unplug the unit from its power source.
b. Disconnect all cables that are connected to the main system unit.
c. Remove any jewelry from your hands and wrists.
d. Use only insulated or non-conductive tools.
2. Remove the computer's cover.
3. Choose an expansion slot. This can be any ISA slot that can accommodate a full length ISA
board.
4. Remove the expansion slot's backplate by removing the screw found at the top of the
backplate. Retain this screw for use in a later step.
5. Install the Supervisor board into the expansion slot. Do not touch the gold fingers on the
connector edge when handling the Supervisor board. Make sure that the board is firmly seated
in the connector slot.
6. Secure the Supervisor board to the computer chassis, using the screw retained in step 4. The
attachment is made at the top of the expansion slot.
7. Make sure that no components on the motherboard (e.g., heat sinks) interfere with the
Supervisor board when it is fully inserted in the motherboard card slot.
8. Replace the computer's cover.
9. Reconnect all devices and cables.
10. Turn the computer power on.
Testing the correctness of the Supervisor board installation can be performed after the Supervisor driver
and related software are installed. Supervisor software installation is discussed in
Section 3.2, Verifying/
Installing the Windows Workstation Software .
3.4.2 Installing the Ethernet Board(s)
Before installing the Micro-PWC system software, one or more Ethernet network interface boards must be
installed. These Ethernet network boards enable the base PC to be wired to an Ethernet network.
To install the Ethernet network board(s), see the installation instructions that are provided with each
Ethernet network board.
3.4.3 Installing the Ethernet Drivers and Related Software
Once the Ethernet network interface board(s) are installed, the drivers and related software for these
board(s) must be installed. The drivers enable the base PC to recognize that the Ethernet network
board(s) have been installed.
To install the drivers and related software for the Ethernet network board(s), see the installation instruc-
tions provided with the software for the network board(s). See your Ethernet network administrator for the
correct address for these Ethernet network board(s).
3.4.4 TCP/IP Verification/Installation
The Micro-PWC system requires the TCP/IP network interface software to be installed on the base PC.
TCP/IP software enables the base PC to communicate with other PCs over a network.
To check to see if the TCP/IP software has already been installed on the base PC, and to install the TCP/
IP software, if necessary, follow the steps below. The figures illustrating this procedure were captured on a
Micro-PWC with a Windows 2000 Professional operating system installed. The procedure is equally valid