Minuteman Kleen Sweep 27M - Manual (Page 10)

10
Replacement of main
broom
The broom roller bears 10 ea. rows of
alterned soft and hard bristles and
consists of two broom halves.
Width:
480 mm (18.9")
Dia.: 250 mm (9.8")
Dia, wear limit: approx. 180 mm (7.1")
The broom roller is replaced as
follows:
GSlue side broom up
GTilt machine back to rest on the
handlebar
Remove three ea. Phillips screws,
turn broom roller 180°, remove
Phillips screws from second half. Pull
the drive pin out of the broom shaft.
To install, reverse above procedure.