Minuteman Kleen Sweep 27M - Manual (Page 12)

12
Replacement of side
broom Vee belt
To remove or to re-install a Vee-belt,
proceed in the following way:
GRemove side broom
GRemove washers, deflector plate
and spacers from broom shaft
(fig. A);
GRemove circlip, pull washers and
pulley with Vee belt off shaft (key
should not drop out from the shaft);
GFit new Vee belt on pulley and re-
assemble (reverse the above pro-
cedure).
Note: After having assembled the
pulley, check for key in place (refer
to sketch right above).
Check:
Move Vee belt to the right, shaft will
have to follow, move Vee belt to the
left, shaft will have to stand still. (view
into side broom arm).
Location of key:
(bottom view, into side broom arm)
Sealing lips
The rubber sealing lips will avoid dust
to be expelled by the broom.
Damaged or worn-out lips will have
to be replaced.
A B