Minuteman E17e - Manual (Page 22)

22
Note: After lowering the brush move The E 17e immediately;
Otherwise the brush might leave traces on the floor. Lift the squeegee during reverse travel.
During work, the power supply cable
Should be lying behind the operator.
When passing over dormers with a height of more than 0.70in =10mm,
The brush drive must be turned off and the brush must be lifted up.
Caution : Danger when passing over the power supply cable while the brush is rotating.
Cleaning of floor areas starts from the outlet socket and is effected stripe by stripe. In case of unoccupied areas it will
be useful to clean at first the border areas, passing with the machine along those areas in counterclockwise sense.
Cleaning of the remaining areas then should be effected stripe by stripe, starting from the outlet socket.
Partially occupied areas should be subdivided into single working areas, within reach of the power Supply cable.
Within short time, the operator will learn how to avoid unnecessary encumberments caused by the cable.
When work is finished:
Stop the machine and lift the brush head.
Lift the squeegee.
Drain and rinse the soiled water
tank (refer to section "Soiled add
fresh water tanks" )
Clean the sealing strips at the
squeegee.
Check the strainer upstream of the
intake opening in the fresh water tank; clean if required, as otherwise the suction efficiency will be affected.
Note: The machine must not becleaned by water jet or high pressure cleaning equipment, as
this will endanger its proper working function.