Minuteman X Ride 28 Riding Extractor - Manual (Page 26)

26
First Operation
The battery/ fault gauge (Fig.
5/3) will flash to signal that the
machine is almost out of pow-
er. When this signal is dis-
played, all functions will shut
off (brushes will turn off, the
scrub deck and vacuum shoe
will raise. The key switch must
be turned OFF then ON to re-
set the machine. The machine
will then only have a few min-
utes left of reserve power for a
short vacuum only mode to
pick up remaining solution on
the floor and transport power to
drive to the battery recharging
station. If the machine is oper-
ated for an excessive period of
time after cleaning functions
have stopped, it will eventually
turn itself off. The machine will
have to be pushed back to the
recharging station. 4.6 Stop Machine
To stop cleaning, select the transport
mode (Fig. 5/13). This will automatically
stop the solution flow, raise the scrub-
deck, and turn off the vacuum motor
(20-second delay).
4.7 After Work
Refer to the “Maintenance” section for
specific maintenance instructions de-
scribed below.
1. When finished cleaning, select the
transport mode (Fig. 5/12), all clean-
ing functions will shut off. Move the
machine to a suitable site for mainte-
nance.
2. Empty and clean the solution tank
3. Empty and clean the recovery tank
Observe the legal directives
and local regulations for dis-
posal of detergents.
4. Remove and clean the vac shoes.
5. Check operating fluid levels, function
and setting.
6. Clean the machine.
Do not clean the electrical
parts by means of high-pres-
sure cleaning equipment.
7. Check the maintenance schedule
and perform any required mainte-
nance before storing the machine.
8. Charge batteries.
9. Store the machine indoors in a clean
dry place.
Keep from freezing
Leave the solution and recov-
ery tank lids open for ventila-
tion to prevent odor build-up.
10.Turn key switch OFF and remove
key.
Remove the key to avoid unau-
thorized use of the machine.