Minuteman X Ride 28 Riding Extractor - Manual (Page 49)

49
Troubleshooting
Problem Possible Cause Remedy
Inadequate solution flow or no solution
to the floor Solution tank empty Fill solution tank
Solution lines, valves, filter or spray jets
clogged Flush lines, and clean solution filter and
spray jets.
Solution solenoid valve Clean or replace valve
Machine does not run Operator seat safety switch Operator has to be seated.Check for
open circuit
Main system controller Check error fault codes
Tripped 100 amp circuit breaker Check for an electrical short circuit.
Reset machine: Reset breaker and turn
key switch off and restart
.
Batteries Low Charge Batteries
Vacuum motor does not turn on Recovery tank full Empty recovery tank
Excessive foaming in recovery tank. Empty recovery tank.
Use less or change chemical
Use defoaming agent
Five LEDs flashing on Battery Gauge Check for motor overload
Reset machine: Turn key switch off and
restart.
Poor Vacuum Performance Motor overload Check individual circuit breakers CB5
and CB6
Brush Motors not running Motor overload Check individual circuil breakers CB3
and CB4