Minuteman E 26 (7061.11) - Manual (Page 37)

35
Maintenance and Care
Height Adjustment
The factory default height adjustment is
2
mm (see illustration). If streaks are
produced, despite an optimum angle
adjustment, the clearance between the
rollers and floor must be adjusted by
changing the number of washers on the
holder.
Try 2mm configuration i
n the case of very
smooth floors, e.g. finished floors, PVC,
linoleum, etc. (2 washers).
Try 3mm configuration in the case of
uneven floors, e.g. grouted tile, etc.
(3 washers).
Try 4mm configuration i
n cases of very
uneven floors, e.g. poorly laid tiles (water
does not run off) (4 washers).
Keep the extra washers by
installing them above the bracket
as shown.
Fig.12
3 mm
2 mm 4 mm