MotorVac TRANSTECH IV - Manual (Page 13)

[email protected] www.motorvac.com
Dipstick Exchange
Warning: It is not necessary to empty the waste tank before beginning an exchange. If beginning an
exchange with fluid in the waste tank ensure that there is less fluid in the clean tank than the remaining
capacity of the waste tank. Failure to do so will result in waste tank overflowing!
1. Fill the TransTech IV new fluid tank with the correct type and amount of Transmission Fluid.
2. Connect TransTech IV power leads to the vehicle’s battery.
3. Press MODE button to select Dipstick operation. Dipstick indicator will be illuminated.
4. Check the transmission fluid level. The Transmission fluid level can be adjusted at this time using the
DRAIN or FILL buttons. This will ensure the service completes with the correct amount of fluid in the
transmission.
5. Measure the vehicle dipstick and set spacer on dipstick fill tube/drain tube on TransTech IV to the correct
length. Insert the TransTech IV tube into the vehicles dipstick tube.
6. Press START/RESUME button to begin service.
10