Nitek VR448COAX - Manual

Model VR448COAX
4-Port PoE Switch with Network Extender
Installation and
Operation Manual
Introduction
The VR448COAX Network Extender is designed to greatly extend the distances to which IP cameras and other
network devices can operate. The VR448COAX Network Extender consists of two units, a 4-port transmitter and a
receiver. Only the transmitter provides PoE to the connected network device. The receiver is installed at the NVR/IP
equipment side and the transmitter at the IP camera side of the installation.
Note: A sticker on the bottom of each unit identifies whether it is the transmitter or the receiver.
NITEK
®
De Schans 19-21 2a
8231 KA Lelystad
Tel: +31(0)320-2300005
Fax: +31(0)320-282186
E-mail: [email protected]
WWW.NITEK.NL
USA
5410 Newport Drive, # 24
Rolling Meadows, IL 60008
Phone: (847) 259-8900
Fax: (847) 259-1300
E-mail: [email protected]
WWW.NITEK.NET
EUROPE
072110 681200106
FRONT
POWER
10/100 Data
Status
ETHERNET
COAX
LINK
Type
Speed Off 10 Mbs
LED Green 100 Mbs
Activity Off No Network
LED On Network Detected
Blinking Network Activity
Speed Off 10 Mbs
LED Green 100 Mbs
Activity Off No Network
LED On Network Detected
Blinking Network Activity
Status Blinking Establishing Link
LED On Link Established
Type On Transmitter
LED Off Receiver
RECEIVER
TRANSMITTER
ETHERNET PORTS
10/100 Data 10/100 Data Data Data 10/100 10/100
Activity Off No Network
LED On Network Detected
Blinking Network Activity
Activity Off No Network
LED On Network Detected
Blinking Network Activity
Speed Off 10 Mbs
LED Green 100 Mbs
Speed Off 10 Mbs
LED Green 100 Mbs
FRONT
Ground
Connection
NITEK
R
POWER INPUT
48 VDC, 1 Amp max.
COAX
POWER
T ype Connected
LINK STATUS
Speed
Type On Transmitter
LED Off Receiver Status Blinking Establishing Link
LED On Link Established
BACK
BACK
NITEK
R
POWER INPUT
12-24 AC/DC, 0-100 Hz
Class 2 only, 1 Amp max.
COMMERCIAL
CCTV PRODUCT
40FE
E325724
Ground
Connection
24 AC/DC