Nitek ET1500UW - Manual (Page 3)

Parts of the ET1500UW
Wire and Cable Recommendations: The ET1500UW is designed to use with ANSI/TIA/EIA defined CAT5e
or CAT6 Unshielded Twisted Pair (UTP) cabling. This UTP cable shall be able to accommodate TCP/IP data
operating speeds of 10/100 Mbps transmission rates. The RJ45 termination pin out schemes shall be in
accordance with the 568B standard. The quality of which must be consistent with any reasonably servicea-
ble cable condition. It must is free from damage such as cuts, breaks, or cracks to the outer covering and
insulated shielding which may compromise the signal conductivity of the cable.
For more specific information regarding wire types, gauges, and proper installation techniques please call
Tech Support at 1-(800)528-4343.
Ethernet & PoE: The ET1500UW is designed to transmit and receive up to 100Mbps of Ethernet data and
PoE from 15.4W (802.3af) to 25.5W (802.3at) at a maximum distance of 2000 feet or 600 meters. Before
considering this solution be sure that the cable involved does not exceed the recommended maximum
lengths. If the cable length value is indeterminate at the time of installation, we recommend the use of a
Ohm meter which measures electrical resistance that can be used to determine unknown cable distances.
NEMA4 Enclosure Case: The NEMA4 enclosure is included in order to provided the system (the
ET1500UW transmitter) with a robust degree of weather and atmospheric condition protection in accordance
with the appropriately rated NEMA level. The weatherproof enclosure allows for flexibility in installation and
can be mounted to a variety of surfaces (mounting hardware dependant & not included), either flat or pole
apparatuses. Two (2) water-proof grommets are located at the bottom of the unit in order to secure cable
terminations and case entry points.
NETWORK PORT SIDE
LINK PORT SIDE
Installation Considerations