Nova-Tech WBW Series - Manual (Page 14)

© Adam Equipment Company 2009 12
NOTE:
When the container is removed a negative value will be shown. If the
scale was tared just before removing the container, this value is the
gross weight of the container plus all products which were removed.
The zero indicator will also be on as the platform is back to the same
condition it was when
[Zero] was pressed last.
Press
[Tare] or [Zero] to remove the tare value and display zero. The
Net indicator will disappear.
10.3 WEIGHING
To determine the weight of a sample, first tare an empty container if
used, then place the sample in the container. The display will show the
weight and the unit of weight currently in use.
To change the weighing unit press the [Unit] key. The available
weighing units are the ones that are enabled by the user in the
parameters section. See section 13.2.
10.4 CHECK-WEIGHING
Check-weighing is a procedure to show a display or cause a beeper to
sound when the weight on the scale meets or exceeds the values
stored in memory. The memory holds values for a high limit and a low
limit. Either or both the limits can be used.
NOTE:
1. The beeper and the LEDs can each be set to OFF (See section
13.1). The LCD display will indicate whenever the weight is within or
exceeds the limits by showing ‘
OK’, ‘HI’ or ‘LO’.
Mass on the balance is above the high limit
Mass is between the limits
Mass is below the low limit