Nova-Tech Chem-Tech XP Series - Manual (Page 3)

REV. L PN J63031 - 3-
1. Introduction
Thank you for your purchase of the Chem-Tech Series XP peristaltic pump from
Pulsafeeder. We appreciate your decision to purchase a Pulsafeeder product.
Please take this time to become familiar with your pump and the number of
accessories that shipped with your product.
The shipping box contains the following items:
1. Peristaltic pump comprising of: (a) pump head and tube assembly, (b) Clear
polycarbonate splash guard with locking thumb screw, and (c) Snap-on rear
splash guard (this can be found in the sealed bag that shipped with the
product).
2. Instruction Manual.
3. Factory replacement tube
4. Suction and Discharge tubing set (15-feet of 1/4-inch or 3/8-inch OD
Polyethylene Tubing).
5. Injector Valve
6. Strainer w/ Ceramic Weight.
2. Safety Instructions
READ AND UNDERSTAND ALL INSTRUCTIONS PRIOR TO USE. Failure to
follow or understand instructions can/may lead to serious injury or death.
•
WARNING: Secure chemicals & metering pumps, making them inaccessible
to children & pets.
•
WARNING: DO NOT PUMP FLAMMABLE LIQUIDS.
•
WARNING: To reduce the risk of electrical shock-before maintenance, repair,
or moving always disconnect the power to the pump by unplugging from wall
outlet.
•
WARNING: Do not tamper with, cut the plug or ground lug off the electrical
cord. Consult a licensed electrician for proper installation.
•
WARNING: Always wear protective clothing, including gloves and safety eye
protection, when working on or near chemical metering pumps, consult
chemical manufacture for protective equipment recommendations.
•
WARNING: Always make sure the voltage on the pump data plate matches
the installation voltage before plugging the pump into a wall outlet or hooking
up to an electrical supply. If you are unsure, have a licensed electrician
inspect and install your pump.
•
WARNING: Always depressurize system and drain the chemical prior to
installation or maintenance.
•
WARNING: Read and fully understand the section on tube replacement.
Failure to do so may lead to serious injury.
•
WARNING: DO NOT MODIFY PUMP , as this poses a potentially dangerous
situation and voids the warranty.
•
WARNING: If the injection point is lower than the chemical tank and pump,
install an anti-siphon valve.