Pach and Company AeGIS 9000P Series Manual User Manual
Page 15
FUNCTION CODE
LOCAL PROGRAMMING
03
LOCK OUT COUNT
(Default setting is 03 )
Minimum setting is 1 and Maximum
setting is 9 .
The system will ignore further
keypad code for 90 second if invalid
keypad code has been entered a
specific number of times.
Does not valid for card code or
combination between card code and
keypad code.
04
TONE OR PULSE
(Default setting is TONE)
If your local phone company does
not support tone dialing mode , you
must set the system for pulse dialing
mode. Most local phone companies
support tone dialing mode.
05
SINGLE OR MULTI SYSTEMS
(Default setting is SINGLE)
If more than one systems are on the
same phone line, you must set each
system to MULTI.
Step 4
Enter the unlock time value (04-99 Seconds) then press #, the display shows
Step 5
Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1
Log on to programming mode (see section 3.1). The display shows
Step 2
Enter Function code 03, then press #, the display shows
Step 3
Enter the Lock Out Count value (1-9) then press #, the display shows
Step 4
Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1
Log on to programming mode (see section 3.1). The display shows
Step 2
Enter Function code 04, then press #, the display shows
Step 3
Enter 1 for Tone and 0 for Pulse then press # the display shows
Step 4
Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1
Log on to programming mode (see section 3.1). The display shows
Step 2
Enter Function code 05, then press #, the display shows
Step 3
Enter 1 for SINGLE or 0 for MULTI, then press #, the display shows
Pach and Company
Chapter 3
Page 10
AeGIS 9000P Series
PROGRAMMING
UNLOCK TIME, SEC
ENTER: 12 PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
LOCK-OUT COUNT
ENTER: 3 PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
TONE=1 PULSE=0
ENTER: 1 PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
SINGLE=1 MULTI=0
ENTER: 1 PRESS #